|
|---|
| Upload Date |
: |
Sat 01 Sep 2007 05:16:31 PM CDT |
| Stamp Credits |
: |
Dark fern - 1693-327B
FW – Summer - 1250-235B |
| Other Supplies |
: |
Yellow cardstock 2 ½” x 3 ½”
Acrylic ATC – 99516A
Embossing powder:
Jazzy orange – EP272
Black detail – EP171
Glitter:
Black Ice – G1020
StazOn Jet Black ink pad - 99704
Versa Mark pad - 99702
Embossing tape ¼” - 99538
Acrylic block
Marvy ink pads: Ochre and Orange
Small piece of bubble wrap.
Small spider shaped ‘sequin’ (can also be punched piece or stamped) |
| Instructions |
: |
1. Attach bubble wrap onto acrylic block with ‘bubble’ side up. Using this as a stamp, stamp yellow cardstock randomly with ochre and orange inks to form background.. Allow to dry.
2. Stamp and emboss Dark Fern with Jazzy Orange EP three times to form ‘spray’ of leaves in upper left hand corner of background as shown.
3. Stamp Fall from FW – Summer stamp three times randomly with black ink on background.
4. Stamp and emboss Dark Fern with Black detail EP on upper right hand corner of acrylic ATC as shown. (Place acrylic piece over background to place fern so orange ferns show through.) See NOTE below. These images could be stamped with black StazOn ink instead of embossing.
5. Turn over acrylic. Stamp and emboss fern again to form branches as shown. Stamping on both sides of the acrylic will give depth to the finished ATC.
6. Glue spider in place on cardstock piece as shown.
7. Attach background piece and acrylic together with embossing tape. Apply Black ice glitter to tape.
(NOTE: When embossing acrylic DO NOT OVERHEAT! Heat just until EP is melted. |
