Christy Gorrow - Florida

Upload Date	:	Tue 11 Dec 2007 07:10:50 PM EST
Stamp Credits	:	Elegance Framed 0757-264G Celebrate in Style 1055-222A Style 745-263B Tango ATC Label 1264-239K
Other Supplies	:	Heavyweight Cardstock, White--3.5” x 2.5” (ATC), 2” x 3” (Elegance), 1” x 2.5” (Style) VersaMark ink pad 99702 Black Detail Embossing Powder EP 171 Sakura Quickie Glue Pen 99202 Sparkling Snow Glitter G1003 Xyron with permanent adhesive cartridge *** Black StazOn ink pad ***If you don’t have a Xyron, I would try putting 2-sided tape on the front side--2 rows on the left side and 1 piece on the other edges. OR another possibility would be to use Sparkle N Sprinkle Brushable Glue after mounting the two design pieces.
Instructions	:	1. Stamp “Celebrate in Style” at very bottom, left corner of ATC (need to leave room for “STYLE” at the top) with StazOn. 2. Turn over and stamp the ATC label on the reverse side. 3. Run through Xyron so adhesive is applied to the front side….set aside. 4. Stamp with VersaMark and emboss with Black Detail--Elegance Framed on the 2” x 3” white CS and Style on the 1” x 2.5” CS. Trim both of these pieces neatly. 5. Using the glue pen, outline the white border around “Style”, then cover the glue with Sparkling Snow. I suggest that you do 2 sides at a time so the glue doesn’t dry and you have a place to hold on. 6. Using the glue pen, fill in the hand mirror, the little space on the lower right edge, as well as the throat and petal of the lily. 7. Assemble by placing “Style” on the top edge of the ATC (centered) and place “Elegance Framed” so the right edge line is even with right edge outline around “Style” -- this is approx 1/8” from edge. Leave the same approx. 1/8” below “Elegance Framed”. 8. Add Sparkling Snow Glitter to all the exposed area of the Xyron adhesive. By putting Sparking Snow over the original stamping of “Celebrate in style”, it will look slightly gray-green and sparkly.